Our Community Forum will be shutting down on June 27, 2024. Please visit att.com/support for all your support needs.

Official

Accepted

Unanswered

Advanced Filters

Search Results (1.9K)

Relevance
Selected Relevance

Accepted Solution

Official Solution

Nokia cell booster (femetocell)

I just received a cell booster from ATT. Model SS2FII femtocell multi-band soho.  The power LED blinks white and the internet LED blinks orange.  The Nokia manual says I need to open udp port 150, 4500, and 123 but I can’t open these ports without the IP address.  Does this unit have

Questions

14.3K

231

0

Accepted Solution

Official Solution

Device not working with Fiber

I have a device that was working fine until my Internet was changed to Fiber. The device requires a router set to use DHCP to provide it with an IP address. Can anyone tell me the specifics about the new modem and how to tell if it is set to use DHCP?

Questions

463

2

Accepted Solution

Official Solution

Use own BGW-320 Fiber Gateway

I am currently renting the BGW320-505 WiFi fiber gateway (installed by ATT technician when I signed up). I've recently purchased the BGW320-500 from Amazon (for about $170), but when I plug it in it's flashing green light and I have no broadband connection according to web control panel (192.168.1.2

Questions

9.8K

30

0

Accepted Solution

Official Solution

ASUS AC-5300 with BGW 210-700 Setup as Router

I need assistance walking through the proper way to set up my ASUS AC5300 router with the att gateway modem BGW 210-700. Been reading about cascading routers/ip passthrough but can't quite get one method to go about setting this up. Any help is appreciated.

Questions

547

3

0

Accepted Solution

Official Solution

Should I not change the Network name and password on the Arris NVG599?

Hi there! After having a lot of trouble with my internet slowing down and shutting off entirely and then turning back on again, an AT&T tech finally came to service my router. He checked the line and it seemed to be OK so he asked if I'd changed the name of my router's Network and Password - of cour

Questions

2.3K

4

0

0

Accepted Solution

Official Solution

Closed

Frequent disconnects when using IP Passthrough

I have a dynamic dns service that runs on my router (ASUS RT-AX86U) which needs to have the proper public IP in order to work. So I setup my BGW320-500 in IP Passthrough to the router and disabled the Wifi on the BGW.  My router obtained the public IP as expected and everything was working fin

Questions

873

19

0

Accepted Solution

Official Solution

5G Netgear Router setup

My I please have the APN settings to setup my device? I had a 4g device and I upgraded to a 5g device. I went into the store and they said I have the correct SIM card for 5G. Thanks

Questions

67

1

0

Accepted Solution

Official Solution

Arlo Base Station Not working on ATT Fiber

Just got ATT fiber and connected my Arlo base station that was working with my previous ISP and wireless router. The Arlo system worked for about an hour but went offline.  I have tried restarting the gateway and factory resetting the Arlo base station several times, but the base station will

Questions

1.3K

5

0

Accepted Solution

Official Solution

AT&T Wireless Internet Device (NetComm IFWA-40)

I am looking into purchasing the AT&T Wireless Internet Device (NetComm IFWA-40) to use while at a lake house over the summer. AT&T has the best (4G LTE) phone coverage in the area (zip code 56273), and phones on AT&T plans are able to play HD YouTube videos and such with relative ease while there,

Questions

871

2

0

Accepted Solution

Official Solution

Can I force a device to connect to my extender instead of the router

I recently installed an extender to ensure the signal strength was strong enough throughout the house. I have noticed however, that the laptop in my office, even though it is close to the extender than the router is connecting to the router and sometimes will get a spotty connection on 5G. Is th

Questions

14.4K

6

0

Accepted Solution

Official Solution

Set Up NETGEAR Router with ATT Fiber

I have the new NETGEAR Nighthawk Whole Home Mesh WiFi 6 System (MK62) - AX1800 Router with 1 Satellite Extender nad trying to set it up with my ATT Fiber BGW210-700. I have looked into other posts but I cannot seem to figure this out and how to make it work correctly. Any help will be appreciated.

Questions

38.1K

26

Accepted Solution

Official Solution

How to monitor traffic on ARRIS BGW210-700?

Suddenly, my internet usage went from under 10GB a day to over 30GB/day. I have not changed anything. How can I figure out where this traffic is coming from through my ARRIS BGW210-700?

Questions

6.4K

2

0

0

Accepted Solution

Official Solution

Port Forwarding from a BGW320-500

Just 'upgraded' and can't seem to get port forwarding to work. I've worked through the HOWTO ( end of this posting ).  The target computer is running linux ( no firewalls turned on - I've specifically turned any/all off) and is physically  connected to the modem via Ethernet.  Finall

Questions

13.8K

13

Accepted Solution

Official Solution

Hardware compatible with ATT Fiber connections?

Fiber 1000 is what I have just ordered for my new apartment coming up later this month. I was told by the sales person supplying my own modem would be a $10/month discount to which I was pleased as I prefer to supply my own hardware. I am, however, having trouble understanding exactly what hardware

Questions

653

0

0

0

Accepted Solution

Official Solution

Closed

Move my at&t router from my kitchen into my office.

How can we get the internet router moved from one room to another at my home

Questions

61

0

0

Accepted Solution

Official Solution

Broadband wire cut

Every time I call technical support I can't get any people to actually pick up the phone to come out and fix my wire. How can I get someone out here?

Questions

310

2

0

Accepted Solution

Official Solution

Should I have received an upgraded router?

When I upgraded to fiber (300), the customer service rep said that the tech would put in an upgraded router. He did not - he said the current one (589) was fine. A few months later, I am just not getting the kind of speed I expected. The speed test that the auto assistant runs is always within the s

Questions

272

0

0

Accepted Solution

Official Solution

Port Forwarding 44158

I’m having trouble forwarding my port to 44158. Step by step instructions please. Any help is appreciated. Thanks.

Questions

211

1

0

Accepted Solution

Official Solution

Is it necessary to have my 2Mhz and 5Mhz radios to have the same SSID

Hello! My router/gateway got reset to factory default for reasons unknown to me. I was setting up the SSIDs for the 2,5 and guest WiFi. When giving the 5Mhz radio a different name than the 2Mhz radio the gateway complains when you go to save it.  I had to turn off the 5Mhz radio since th

Questions

123

2

0

Accepted Solution

Official Solution

How do I improve the speed on my 5268AC router?

Hello I have a 5268AC router and am currently on a 100MBPS plan. I am getting nice fast speeds of 5-35mbps.    I have tried rebooting it. Consisting of unplug for 1 minute plug back in. Have done this twice within 2 weeks.  Also I have tried going to less congested channel

Questions

360

1

0

Not finding what you're looking for?
New to AT&T Community?
New to the AT&T Community? Start by visiting the Community How-To.
New to the AT&T Community?
Visit the Community How-To.