Mentor
•
53 Messages
Noisy line - UV Realtime pics
Hoping to catch SomeJoe's attention... Apologize in advance if these pic's don't come out right, first post.
Profile Page
Error Table
Interfaces
Bitloading
As I understand the documentation, this is a very noisy line... Remarkably, I'm still pulling 11.5 ish down and 1 up on speedtest.net
What if anything should I look into as far as correcting things?
2nd question on the Channels / Streams tab: I'm running a config as referanced in your section 3, router behind gateway. I have a Dlink DGL-4500 "gaming" router, capable of some limited multicast routing. Just wondering if there's anything that can be done so that I can have my cake and eat it too (see the STB's even though I have a router between my PC and the gateway)... With the capabilities of this router, I would think I should be able to get it working...
SomeJoe7777
Expert
•
9.4K Messages
12 years ago
You're showing no uncorrected blocks or or other signal loss errors, which is great. I'd say your line looks to be fixed.
0
0
rottielover
Mentor
•
53 Messages
12 years ago
Just wanted to say "Thank you" to all those who helped me out on this!!!
0
0
SomeJoe7777
Expert
•
9.4K Messages
12 years ago
0
0
rottielover
Mentor
•
53 Messages
12 years ago
😞 uhg.
My wife called me this morning to tell me that the TV and Phones are working, but that the internet is not.
When I get home from work, I'll investigate, in the mean time, does anyone know of any outages or localized problems in the St. Louis Area?
0
0
ereet
Mentor
•
81 Messages
12 years ago
we had a vrad port go out - they fixed everyone and my stats went from 38K (32/5 profile 2200ft) to 45K (32/5 profile 2100ft) - same wires. i was barely on 32/5 and now i have 87% (before as high as 110% overallocated) 3801 was the only way to get 32/5 profile the 3800 couldn't do it back then.
0
0
rottielover
Mentor
•
53 Messages
12 years ago
Interesting...
Sorry for the delay'd response. By the time I got home, internet was working again. I checked all the router stats with UVRealtime but nothing showed up. In fact the error table was only showing about 2k corrected blocks.
I have no idea what happened.
Keeping an eye on things.
0
0
bay7area
Voyager
•
3 Messages
11 years ago
Somejoe : Power Level" power level @ the house ? or Power level from the Vrad?
My Noise Margin and attenuation can be improve right?
It's only 15 foot of cat5 running to the router: thanks for checking it outl
0
0
SomeJoe7777
Expert
•
9.4K Messages
11 years ago
Your line looks like you may have an attenuator installed because you're very close to the VRAD. The values reported are normal for an installation with an attenuator.
I don't think anything needs to be done. To verify, just watch the error table to ensure that an unusual number of errors aren't accumulating.
0
0