Our Community Forums will be closing on June 27, 2024. Please visit att.com/support for all your support needs.
ems4him's profile



1 Message

Wednesday, May 13th, 2015 5:12 AM

iPhone app - custom route traffic using sonicwall to ATT UVERSE GW

I've been reading several posts about how its possible to configure the UVERSE apps to send multicast traffic through a 3rd party router to the GW of the UVerse box.


My setup is this:


1)  Aruba AP > Managed Switch > Sonicwall Router > ISP


2)  Uverse Network for TVs only (WiFi turned off... its logically and physically independent of above configuration)  


They are on separate subnets as well.  ( &


I have separate ISP and the uverse TVs are not connected to the same switch.


I've connected a cable from my sonic wall to the Uverse switch (on the RG itself) to essentially "bridge" the connection...


I am trying to make the apps recognize the connected ATT Gateway 


I know that Uverse uses SSDP protocol on 239.255..... but am a little iffy on the sonicwall configuration itself.


I have tried making a handful of access rules, address objects etc... and would love your help!





ACE - Expert


36K Messages

9 years ago

Per AT&T's published requirements, AT&T U-verse High Speed Internet is a requirement to use the U-verse apps to control IPTV Receivers.  I believe this requirement is actually enforced.


So, the fact that you say you have another HSI provider would appear to spell doom for your plan.

Not finding what you're looking for?
New to AT&T Community?
New to the AT&T Community? Start by visiting the Community How-To.
New to the AT&T Community?
Visit the Community How-To.