
New Member
•
3 Messages
Is it possible to access router settings after IP passthrough?
I was having problems with disconnecting on the BGW210-700 ATT modem so I did IP passthrough to my ASUS RT-AX86U.
Everything connects fine except my TCL55 Roku TV. It would connect fine at first and then all of a sudden it doesn't work anymore unless I restart my modem and router.
My other issue is, I seem to not be able to access my Asus Router settings page using 192.168.50.1 or router.asus.com.
Is it possible to access the Asus Router page?
Do you know if there is a fix for my Roku TV disconnecting?
browndk26
ACE - Professor
•
5K Messages
10 months ago
I access my asus router away from home and at home with no trouble with my gateway in ip passthrough. Did you restart your asus after setting the gateway to ip passthrough? Is your asus wan ip the same as the gateway ipv4 address? Is the Roku tv connecting wired or wirelessly?
0
0
JefferMC
ACE - Expert
•
32.3K Messages
10 months ago
There's no reason why you shouldn't be able to connect to the ASUS's management page at http://192.168.50.1 assuming (a) that's the ASUS's IP and (b) you're connected to the ASUS (and not the BGW210).
How far from your ASUS is your TV?
Did you turn off the Wi-Fi on your BGW210 to reduce interference for your ASUS?
(edited)
0
0
yeansoun
New Member
•
3 Messages
10 months ago
I'm wondering if I connected my router correctly? I plugged the ethernet wire from the #1 port on the BGW to my #1 ASUS port.
My TV is very close to the router, it is connected wirelessly.
I turned off the Wi-Fi on the BGW
IP for the BGW is 192.168.1.254
IP for Asus is 192.168.50.1
I am still able to log into the BGW
0
yeansoun
New Member
•
3 Messages
10 months ago
turns out I plugged the router wrong. I plugged the ethernet to the WAN and now everything is working correctly.
0
ATTHelp
Community Support
•
215.2K Messages
10 months ago
We're glad to hear everything is now working okay, @yeansoun.
Feel free to reach back out with any other questions or concerns, and thank you for contacting the AT&T Community Forums Team.
Elmi, AT&T Community Specialist.
0
0
kdavis12367
New Member
•
3 Messages
3 months ago
I have set my Netgear NightHawk up in Passthrough mode. I'm still able to access the AT&T router. My setup is from the AT&T internet port to my Netgear Internet port. Is this correct? Or should the AT&T internet port be plugged into one of the other ports on the Netgear router.
0
0
JefferMC
ACE - Expert
•
32.3K Messages
3 months ago
Normally if you have router with an AT&T Gateway, you hook the WAN port of your router to any one of the LAN ports on the Gateway.
0
0
kdavis12367
New Member
•
3 Messages
3 months ago
No that didn’t work. I’m accessing the AT&T router still.
0
0
JefferMC
ACE - Expert
•
32.3K Messages
3 months ago
Please explain what you mean by that and what you expect to happen instead?
0
0
kdavis12367
New Member
•
3 Messages
3 months ago
If I set the AT&T BGW320-500 in Passthrough mode has specified, and placing my router into one of the other modem ports on AT&T router. I shouldn’t be able to access the 192.168.1.254 address from my network side.
0
0